View Profile: Huboe - The Organ Forum

Yesterday, 10:13 PM

jdoc replied to a thread Leslie Extract in Leslies, Tone Cabinets, and Accessories

still has to be proper TYPE OF wire for ac as do all components, code is there for A GOOD REASON, LOW VOLTAGE IS USED FOR A REASON.....ie: doorbells...

12 replies | 255 view(s)

Yesterday, 08:53 PM

Wes replied to a thread AO-28 electronic swell pedal in Hammond Organs

"plug and play" - Use a really, really strong magnet pair to connect the wire to the pedal.

12 replies | 216 view(s)

Yesterday, 08:51 PM

Wes replied to a thread Leslie Extract in Leslies, Tone Cabinets, and Accessories

FWIW the switch I use in my end-block is rated for 5A at 250V, plenty for Leslie motors, although I only use it to run the Leslie relay! Similarly,...

12 replies | 255 view(s)

Yesterday, 05:16 PM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

You have obviously never played with a too-loud drummer.

50 replies | 744 view(s)

Yesterday, 05:07 PM

Wes replied to a thread Red Paint in Hammond Organs

Is there any chance you are looking a rust-coloured flux?

3 replies | 88 view(s)

Yesterday, 04:41 PM

jdoc replied to a thread Any Thoughts on the Pari.e New K-61? in Hammond Organs

pictures, video please?

14 replies | 303 view(s)

Yesterday, 01:09 PM

jdoc replied to a thread Leslie Extract in Leslies, Tone Cabinets, and Accessories

no reason to switch with ac voltage in this day and age, having 120volts out to a switch requires heavier wire rated for AC, rated switch (more...

12 replies | 255 view(s)

Yesterday, 12:51 PM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Looks like I misunderstood! That schematic looks just fine to me. 1A might be a bit small for the startup torque required by the fast motor, but...

50 replies | 744 view(s)

Yesterday, 12:45 PM

Wes replied to a thread A102 hum from line-in rca when nothing connected in Hammond Organs

I was also going to suggest a resistor. It's the right solution IME with stuff like this. I would start with something high, like 10K, and get as...

5 replies | 112 view(s)

Yesterday, 02:36 AM

Wes replied to a thread AO-28 electronic swell pedal in Hammond Organs

Are you playing an AO-28 organ? If so .. you could use the capacitor in the amp and connect to it with a motorcycle cable. A good bike shop can...

12 replies | 216 view(s)

Yesterday, 02:33 AM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Can you post your drawing? Either I made a mistake understanding your explanation, or you will create a short circuit with the relay in one of its...

50 replies | 744 view(s)

Yesterday, 12:38 AM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Draw it out. I think you have this wrong.

50 replies | 744 view(s)

05-23-2013, 10:29 PM

jdoc replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

you got it my friend

50 replies | 744 view(s)

05-23-2013, 07:59 PM

Wes replied to a thread Preparing to remove the tone generator from my CV in Hammond Organs

I'll second David's advice for a soldering station; I own a Weller WES51 and it has made my life SO MUCH better. Not only do I no longer burn PCBs,...

10 replies | 163 view(s)

05-23-2013, 07:51 PM

Wes replied to a thread Polishing plastic cheekblocks? in Hammond Organs

We made stuff out of acrylic(?) in grade 8 shop class oh-so-many years ago. I was always impressed at how quickly you could put a nice shine on it...

5 replies | 149 view(s)

05-23-2013, 07:42 PM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Yep, right there. Double-check with your meter, but I think you're looking for the BL and YEL terminals.

50 replies | 744 view(s)

05-23-2013, 06:42 PM

jdoc replied to a thread Strange Looking Fuse ?? in General Chat

that is a normal but not common fuse as the blob absorbs spikes (like a capacitor except for heat) but still allows the fuse to blow relatively...

2 replies | 58 view(s)

05-23-2013, 04:36 PM

jdoc replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

was using the KISS principle>>>>as in oil is not compressible which is how hydraulics work......it is but due to the atomic structure very little...

50 replies | 744 view(s)

05-23-2013, 04:12 PM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Actually, it's not a motor-start cap, it's a motor-run cap. The synchronous self-starting motor in the L/E/H/T-x00 organs basically uses a two-phase...

50 replies | 744 view(s)

05-23-2013, 02:15 PM

jdoc replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

motor capacitor on the L100 motor(used to start the motor)

50 replies | 744 view(s)

05-23-2013, 12:15 PM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Follow the wires from the motor cap. Two of them go there, and IIRC terminate on the lugs you need to be using. This is nowhere near the amp. Wes

50 replies | 744 view(s)

05-23-2013, 03:53 AM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

Also, the 120VAC should come from under the steel plate near the motor cap. There are three wires under there; switched hot, unswitched hot, and...

50 replies | 744 view(s)

05-23-2013, 02:08 AM

jdoc replied to a thread Slightly off-topic, I suppose: Rhodes pianos in General Chat

back in the day.............................1973?

8 replies | 168 view(s)

05-23-2013, 02:03 AM

jdoc replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

top is slow (small motor as less torque required) and yes motor wires have no polarity. Are you changing orientation of unit from vertical to...

50 replies | 744 view(s)

05-23-2013, 01:49 AM

jdoc replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

the slow motor is the one with the small shaft that runs the "tire", the ac wires don't matter much, one black from each are common and the other...

50 replies | 744 view(s)

05-23-2013, 01:03 AM

jdoc replied to a thread Question about Farfisa Professional 222 in Combo Organs & Keyboards

owned one in my youth, it has its own sound but rocks thru a Leslie

4 replies | 61 view(s)

05-23-2013, 01:00 AM

jdoc replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

wall wart power transformer, I have a crate of old ones from 1.5 to 28 volts

50 replies | 744 view(s)

05-23-2013, 12:58 AM

jdoc replied to a thread Preparing to remove the tone generator from my CV in Hammond Organs

Lots of pictures and go to a home store or electrical supplier an buy some numbers for each wire...........

10 replies | 163 view(s)

05-22-2013, 11:32 PM

M3me replied to a thread Now Playing. in Hammond Organs

VERY cool video, CEB. What a pair of humans those two are. While that's an excellent example, what I've alwyas imagined is if there were the...

480 replies | 16689 view(s)

05-22-2013, 08:19 PM

Wes replied to a thread Thoughts and tips on L100 keyclick mods in Hammond Organs

I'll describe it in words, because you need to understand this clearly in order to safely wire it up and test it before turning it on. The relay...

50 replies | 744 view(s)

Welcome To The Organ Forum

Internet Explorer 10

Huboe
Member

Mini Statistics

More 9 Friends

jdoc

Brendon Wright

peanut

wilsonsk

jimmywilliams

Wes

Recent Visitors

Basic Information

About Huboe

Signature

Statistics

Total Posts

Wiki

General Information

9 Friends

Brendon Wright

jdoc

JGH1

jimmywilliams

M3me

peanut

Wes

wilsonsk

Ydocz11

Welcome To The Organ Forum

Internet Explorer 10

Huboe Member

Mini Statistics

More 9 Friends

Recent Visitors

Basic Information

About Huboe

Signature

Statistics

Total Posts

Wiki

General Information

9 Friends

Huboe
Member